hasalien.blogg.se - Mikrotik routeros what is master port

Note: By default serial0 is used by serial-terminal. port remote-access add port=serial0 protocol=rfc2217 tcp-port=9999 If you want to access serial device that can only talk to COM ports and is located somewhere else behind router, then you can use remote-access.Īs defined in RFC 2217 RouterOS can transfer data from/to a serial device over TCP connection.Įnabling remote access on RouterOS is very easy: This submenu allows to specify directory where drivers for 3g modems can be uploaded and used. For example, by default Serial0 is used by serial-console. Number of channels supported by the port. Electronic devices usually uses 1 stop bit.

Whether to enable RS-232 RTS signal circuit used by flow control. In most cases parity is set to none and errors are handled by the communication protocol. If enabled, extra bit is sent to detect the communication errors. Method of flow control to pause and resume the transmission of data.Įrror detection method. Whether to enable RS-232 DTR signal circuit used by flow control.įlow-control ( hardware | none | xon-xoff Default: )

8 - any data (matches the size of a byte).

The number of data bits in each character. If set to auto, then RouterOS tries to detect baud rate automatically. Note: List of the ports are maintained automatically by the RouterOS.īaud-rate ( integer | auto Default: auto)īaud rate (speed) used by the port.